CatEye PW-TR100 Power Unit - Manual (Page 5)

5
PW-TR100 : POWER UNIT
Battery unit
Warning!!! • Never charge, cause a short-circuit of, increase the temperature of, or disas-
semble the battery. Do not dispose of it in a fire either. Doing so may generate heat
or cause a leak or burst and may result in injury or burning.
• Do not leave any battery within the reach of children, and dispose of them cor-
rectly. If a battery is swallowed, consult a doctor immediately.
CAUTION ! • Be careful to orient the batteries correctly.
• Do not mix old and new batteries.
• Remove the batteries from the unit whenever you are planning to store the bicycle for
a long period of time or when the batteries are exhausted.
ON-Power/OFF-Power
Turning power ON or OFF determines if the power-related data is recorded or not.
Since this data can use up memory allocation, power may be turned OFF in the following situations:
• If simply do not need to see or record power-related data.
• If the power unit is not going to be used and the main unit is installed on the bracket from the TR100
• If the battery unit is removed
NOTE: Make sure to set the Power select option to OFF in the following situations:
• When the main unit is used without the Power sensor.
• When the Power sensor is disconnected from the main unit.
If measurement is carried out with the Power select option ON, refer to “Trouble on
operation” on page 65.
• If the Power select is OFF, measurement of other data can be carried out as normal as long
as the main unit is attached to the TR100 bracket or to the power unit.