AMD Geode SC1201 - Manual (Page 103)

AMD Geode™ SC1200/SC1201 Processor Data Book 103
SuperI/O Module 32579B
5.4.2.5 LDN 05h and 06h - ACCESS.bus Ports 1 and 2
ACCESS.bus ports 1 and 2 (ACB1 and ACB2) are identi-
cal. Each ACB is a two-wire synchronous serial interface
compatible with the ACCESS.bus physical layer. ACB1 and
ACB2 use a 24 MHz internal clock. Six runtime registers for
each ACCESS.bus are described in Section 5.7
"ACCESS.bus Interface" on page 121.
ACB1 is designated as LDN 05h and ACB2 as LDN 06h.
Table 5-13 lists the configuration registers which affect the
ACCESS.bus ports. Only the last register (F0h) is
described here (Table 5-14). See Table 5-3 "Standard Con-
figuration Registers" on page 95 for descriptions of the oth-
ers.
Table 5-13. Relevant ACB1 and ACB2 Registers
Index Type Configuration Register or Action
Reset
Value
30h R/W Activate. See also bit 0 of the SIOCF1 register 00h
60h R/W Base Address MSB register. 00h
61h R/W Base Address LSB register. Bits [2:0] (for A[2:0]) are RO, 000b. 00h
70h R/W Interrupt Number. 00h
71h R/W Interrupt Type. Bit 1 is R/W. Other bits are RO. 03h
74h RO Report no DMA assignment. 04h
75h RO Report no DMA assignment. 04h
F0h R/W ACB1 and ACB2 Configuration register. 00h
Table 5-14. ACB1 and ACB2 Configuration Register
Bit Description
Index F0h ACB1 and ACB2 Configuration Register (R/W)
This register is reset by hardware to 00h.
7:3 Reserved.
2 Internal Pull-Up Enable.
0: No internal pull-up resistors on AB1C/AB2C and AB1D/AB2D. (Default)
1: Internal pull-up resistors on AB1C/AB2C and AB1D/AB2D.
1:0 Reserved.