4 audio registers - function 3, Table 6-37, F3: pci header registers for audio configuration – AMD Geode SC1201 User Manual

Page 262: Table 6-37)

Advertising
background image

262

AMD Geode™ SC1200/SC1201 Processor Data Book

Core Logic Module - Audio Registers - Function 3

32579B

6.4.4

Audio Registers - Function 3

The register designated as Function 3 (F3) is used to con-
figure the PCI portion of support hardware for the audio
registers. The bit formats for the PCI Header registers are
given in Table 6-37.

A Base Address register (F3BAR0), located in the PCI
Header registers of F3, is used for pointing to the register
space designated for support of audio, described later in
this section.

Table 6-37. F3: PCI Header Registers for Audio Configuration

Bit

Description

Index 00h-01h

Vendor Identification Register (RO)

Reset Value: 100Bh

Index 02h-03h

Device Identification Register (RO)

Reset Value: 0503h

Index 04h-05h

PCI Command Register (R/W)

Reset Value: 0000h

15:3

Reserved. (Read Only)

2

Bus Master. Allow the Core Logic module bus mastering capabilities.

0: Disable.

1: Enable. (Default)

This bit must be set to 1.

1

Memory Space. Allow the Core Logic module to respond to memory cycles from the PCI bus.

0: Disable.

1: Enable.

This bit must be enabled to access memory offsets through F3BAR0 (See F3 Index 10h).

0

Reserved. (Read Only)

Index 06h-07h

PCI Status Register (RO)

Reset Value: 0280h

Index 08h

Device Revision ID Register (RO)

Reset Value: 00h

Index 09h-0Bh

PCI Class Code Register (RO)

Reset Value: 040100h

Index 0Ch

PCI Cache Line Size Register (RO)

Reset Value: 00h

Index 0Dh

PCI Latency Timer Register (RO)

Reset Value: 00h

Index 0Eh

PCI Header Type (RO)

Reset Value: 00h

Index 0Fh

PCI BIST Register (RO)

Reset Value: 00h

Index 10h-13h

Base Address Register - F3BAR0 (R/W)

Reset Value: 00000000h

This register sets the base address of the memory mapped audio interface control register block. This is a 128-byte block of registers
used to control the audio FIFO and codec interface, as well as to support VSA SMIs. Bits [11:0] are read only (0000 0000 0000), indicat-
ing a 4 KB memory address range. Refer to Table 6-38 on page 263 for the audio configuration register bit formats and reset values.

31:12

Audio Interface Base Address.

11:0

Address Range. (Read Only)

Index 14h-2Bh

Reserved

Reset Value: 00h

Index 2Ch-2Dh

Subsystem Vendor ID (RO)

Reset Value: 100Bh

Index 2Eh-2Fh

Subsystem ID (RO)

Reset Value: 0503h

Index 30h-FFh

Reserved

Reset Value: 00h

Advertising
This manual is related to the following products: