Barco E1 - Manual (Page 36)

Windows 2000 BarcoMed Nio software installation
System manual E1 37
Windows 2000 BarcoMed Nio software installation
Note: These instructions apply to both Windows ® 2000 and
Windows ® XP.
Preparation
Prior to installing your E1 software the following should be done.
1. Install the BarcoMed Nio display controller(s) in your system.
2. Connect the E1 display panel(s) to the BarcoMed Nio display
controller(s) and power supply(s).
3. Decide if you want to install the NioWatch Software in
addition to the driver.
4. Decide if you are going to install the BarcoMed Nio driver
with DualView enabled or disabled) (see Step “7.” on
page 42 for a description of DualView).
5. Decide which Palette Mode you wish to use with the
BarcoMed Nio display controller. If you are uncertain, use the
default setting as this setting can be changed later using the
BarcoMed Driver Tab of the Windows Display Properties
control panel.
Using the BarcoMed product installation wizard
To install your BarcoMed Nio Windows display controller driver
Software for the first time follow the steps below.
If you are reinstalling the drivers or installing a new driver
release over an existing driver release you may skip steps 2 and
3 below:
1. Boot your system, and log in using an account with
administrator privileges.
2. For each BarcoMed Nio display controller installed in your
system Windows will launch the “Found New Hardware
Wizard”. Click “Cancel”. Continue to click “Cancel” until
Windows stops launching the “Found New Hardware