Barco E1 - Manual (Page 40)

Windows 2000 BarcoMed Nio software installation
System manual E1 41
your E1 Software CD. Select the device you want to install
and then click “Next”.
Note: If there are no BarcoMed devices installed, or if
Windows does not recognize the installed devices, or if the
driver on your E1 Software CD does not support the installed
devices, the dialog box will be empty
1
, and the BarcoMed
driver wizard will exit when you click “Finish” or “Cancel”.
Figure 18: Sample device selection screen, the device shown in
your system may be different.
Caution: You can install the driver for only one type of
BarcoMed device at a time. If you have multiple types of
BarcoMed devices installed in your computer, you will need
to rerun the installer to install the drivers for the other
devices.
If you select a device with an installed driver, the wizard will
warn you if the installed driver is newer than the one you
are installing (see figure 19 on page 42).
1. If Windows does not recognize the installed BarcoMed device, special settings
may need to be made in the BIOS to support non-AGP video controllers or to
support multiple video controllers. Check with your PC manufacturer.