Barco E1 User Manual
Page 41
Windows 2000 BarcoMed Nio software installation
42
System manual E1
Figure 19
Click “OK” to install the new driver. If you don’t want to
replace the exiting driver, click “OK” and then click
“Cancel”.
7. Your selection on the "Enable DualView" screen (figure 20
below) determines if DualView is enabled or not. DualView
allows a dual head display controller to display two separate
desktops, one for each display instead of a single virtual
desktop that spans across both displays.
Figure 20
The difference between running with DualView enabled or
disabled is shown in figures 21 and 22 on page 43. If you
wish to enable DualView “check” the checkbox next to
"Enable the DualView device?", and click "Next". If you do
not wish to enable DualView “clear” the checkbox next to
"Enable the DualView device?", and click "Next" to continue.