Controls and displays 02 – Pioneer VSX-420-S User Manual

Page 12

Advertising
background image

Controls and displays

02

12

En

Press

first to access:

BASS –/+
Use to adjust Bass

1

TRE –/+
Use to adjust Treble

1

11 Number buttons and other component
controls

2

Use the number buttons to directly select the
tracks on a CD, DVD, etc. There are other
buttons that can be accessed after the

button is pressed. (For example

TEST TONE, etc.)

HDD*, DVD*, VCR*
These buttons switch between the hard
disk, DVD and VCR controls for HDD/DVD/
VCR recorders.

TEST TONE
Outputs the test tones on each channel.

Use the

/ buttons to select the channel

and use the

/ buttons to adjust the

level on each channel. Pressing

TEST

TONE again exits the test tone mode.

CH SELECT
Press repeatedly to select a channel, then
use

LEV +/– to adjust the level (page 34).

LEV +/–
Use to adjust the channel levels.

SPEAKERS
Use to change the speaker system on or
off. When the

SP OFF is selected, no sound

is output from the speakers connected to
this receiver.

DIMMER
Dims or brightens the display. The
brightness can be controlled in four steps.

12

SOURCE

Turns on or off the power of the Pioneer DVD/
DVR units when

BD, DVD or DVR is selected

using the

MULTI CONTROL buttons.

13 TV CONTROL buttons
These buttons can control only be used with
Pioneer TVs.


Use to turn on/off the power of the TV.

INPUT
Use to select the TV input signal.

CH +/–
Use to select channels.

VOL +/–
Use to adjust the volume on your TV.

DTV/TV*
Switches between the DTV and analog TV
input modes for Pioneer TVs.

14 MASTER VOLUME +/–
Use to set the listening volume.

15 MUTE
Mutes/unmutes the sound.

16 DISP
Switches the display of this unit. The input
name, listening mode or sound volume can be
checked by selecting an input source.

17 SHIFT
Press to access the ‘boxed’ commands (above
the buttons) on the remote. These buttons are
marked with an asterisk (

* ) in this section. This

button is also used for operating ZONE 2
(page 37).

Note

1 The tone controls are disabled when the listening mode is set to

DIRECT or PURE DIRECT.

2

SB CH button is not used with this receiver.

RECEIVER

RECEIVER

VSX-420_SY_En.book 12 ページ 2010年3月19日 金曜日 午前9時37分

Advertising
This manual is related to the following products: