Pioneer VSX-420-S - Manual (Page 37)

Using the MULTI-ZONE feature 06
37
En
English
Français
Italiano
Español
Nederlands
Deutsch
Using the MULTI-ZONE controls
The following steps use the front panel controls
to select sources. See MULTI-ZONE remote
controls below.
1 Press the MULTI-ZONE ON/OFF button
on the front panel.
Each press selects a MULTI-ZONE option:
• ZONE 2 ON – Switches the MULTI-ZONE
feature on
• ZONE 2 OFF – Switches the MULTI-ZONE
feature off
The ZONE indicator lights when the MULTI-
ZONE control has been switched ON.
2 Press CONTROL.
• When the receiver is on, 1 make sure that
any operations for the sub zone are done
while
ZONE 2 shows in the display. If this is
not showing, the front panel controls affect
the main zone only.
3 Use the INPUT SELECTOR dial to select
the source for the zone you have selected.
For example,
Z2: CDR sends the source
connected to the CDR inputs to the sub room
( ZONE 2).
• If you select TUNER, you can use the tuner
controls to select a preset station (see
Saving station presets on page 38 if you’re
unsure how to do this).
2
4 When you’re finished, press CONTROL
again to return to the main zone controls.
You can also press the
MULTI-ZONE ON/OFF
button on the front panel to switch off all
output to the sub zone.
3
MULTI-ZONE remote controls
Press the button on the remote
control, then with the SHIFT button pressed,
press the buttons below to operate the
corresponding zone.
The following table shows the possible MULTI-
ZONE remote controls:
a. In ZONE 2, you cannot select MULTI IN inputs.
Note
1 If the receiver is in standby, the display is dimmed, and ZONE2 ON continues to show in the display.
BAND
PHONES
INPUT
SELECTOR
STANDBY/ON
PHASE CONTROL
AUTO SURROUND/ STREAM DIRECT STEREO/ A.L.C. ADVANCED
SURROUND STANDARD
SURROUND MASTER
VOLUME SPEAKERS CONTROL MULTI-ZONE ON/OFF
PORTABLE
TUNER EDIT ENTER
AUDIO / VIDEO MULTI -CHANNEL RECEIVER VSX-420
TUNE TUNE + PRESET PRESET +
CONTROL MULTI-ZONE ON/OFF
SPEAKERS CONTROL
MULTI-ZONE
ON/OFF
2 The tuner cannot be tuned to more than one station at a time. Therefore, changing the station in one zone also changes the
station in the other zone. Please be careful not to change stations when recording a radio broadcast.
3 • You won’t be able to switch the main zone off completely unless you’ve switched off the MULTI-ZONE control first.
• If you don’t plan to use the MULTI-ZONE feature for a while, turn off the power in both the sub and main rooms so that this
receiver is in standby.
• Volume level cannot be adjusted with this receiver. Use the separate amplifier connected to the
ZONE2 OUT to adjust the
volume.
Button What it does
 RECEIVER Switches on/off power in the sub
zone.
INPUT
SELECT Use to select the input source in the
sub zone.
MULTI
CONTROL
buttons Use to select the input source directly
in the sub zone.
a
RECEIVER
VSX-420_SY_En.book 37 ページ ２０１０年３月１９日 金曜日 午前９時３７分