Pioneer VSX-420-S - Manual (Page 44)

Additional information 09
44
En
HDMI
Resetting the main unit
Use this procedure to reset all the receiver’s
settings to the factory default. Use the front
panel controls to do this.
1 Switch the receiver into standby.
2 While holding down the BAND button,
press and hold the  STANDBY/ON button
for about two seconds.
3 When you see RESET? appear in the
display, press the ‘AUTO SURROUND/
STREAM DIRECT’ button.
OK? shows in the display.
4 Press ‘STEREO/A.L.C.’ to confirm.
OK appears in the display to indicate that the
receiver has been reset to the factory default
settings.
Can’t operate the remote
control. • Replace the batteries (refer to page 8).
• Operate within 7 m, 30
° of the remote sensor on the front panel
(refer to page 6).
• Remove the obstacle or operate from another position.
• Avoid exposing the remote sensor on the front panel to direct light.
The display is dark or off. • Press DIMMER on the remote repeatedly to return to the default.
Symptom Remedy
No picture. • If the problem still persists when connecting your HDMI component
directly to your monitor, please consult the component or monitor
manual or contact the manufacturer for support.
• Depending in the output settings of the source component, it may be
outputting a video format that can’t be displayed. Change the output
settings of the source, or connect using the component or composite
jacks.
• If video images do not appear on your TV, try adjusting the resolution,
Deep Color or other setting for your component.
• To output signals in Deep Color, use an HDMI cable (High Speed
HDMI
®
Cable) to connect this receiver to a component or TV with the
Deep Color feature.
No sound, or sound
suddenly ceases. • Since the HDMI audio signal is sent through this receiver to your TV,
you need to make separate connections for audio if you want to hear your
HDMI component through this system. See Connecting using HDMI on
page 18 for more on this.
Problem Remedy
VSX-420_SY_En.book 44 ページ ２０１０年３月１９日 金曜日 午前９時３７分