Pioneer VSA-AX10 - Manual (Page 30)

30
En
7 i.LINK connectors
Use a 4-pin, S400 i.LINK cable, less than 3.5 m long,
to connect i.LINK-equipped components.
Be sure to insert the i.LINK cable straight into
connector. When properly aligned the cable can be
inserted with little resistance. Forcing the cable into
the connector will damage the connector pins.
The arrow on the
cable connector body
should be face down
for corrrect alignment
with the connector on
the amplifier.
memo
Using i.LINK Interface
• When properly connected, the i.LINK plug will snap into the connector. If not connected
properly the amplifier will not be able to recognize any connected components.
• After connecting an i.LINK-equipped component to the amplifier, follow the instructions
for both assigning inputs on the amplifier (see p.87) and output settings on the compo-
nent (see the manual that came with the component).
• You can connect several i.LINK-equipped components together in the same way. See
Creating an i.LINK Network below.
• There may be cases where the PQLS/rate control function and/or the i.LINK audio does
not work properly even when connected to an i.LINK-Audio-compatible equipment.
• Do not connect/disconnect i.LINK cables or switch on/off any components connected
using i.LINK while the amplifier is on.