Pioneer VSA-AX10 - Manual (Page 39)

39
En
PREP
ARA
TION
PREP
ARA
T
ION
Display
All the display information is explained and/or referenced here.
ATT – Lights when INPUT ATT is used to
reduce the level of the analog source signal.
5 Character display
Shows current mode, status, etc.
6 Digital format indicators
DIGITAL : Lights when a Dolby Digital
signal is detected.
: Lights when a DTS signal is detected.
MPEG : Lights when an MPEG signal is
detected.
: Lights when the HOME THX mode is
selected.
: Lights during Surround EX matrix process-
ing.
: Lights when a decoding DTS-ES audio.
DISC : Lights during DTS-ES discrete process-
ing.
MTRX : Lights during DTS-ES matrix process-
ing.
PRO LOGIC : Lights during Dolby Pro Logic II
processing.
Neo :6 : Lights during Neo: 6 processing.
2ch PLAYBACK : Lights during two-channel
playback.
7 Speaker indicators
Light to indicate the current speaker system, A
and/or B.
8 TAPE 2 indicator
Lights when the TAPE 2 monitor is on.
9 i.LINK indicator (see p.50, step 3)
Lights when an i.LINK-audio-equipped
component is selected.
1 SIGNAL SELECT indicators
Light to indicate the input signal you selected.
Since there is no indicator light for i.LINK, when
it is selected none of the indicators listed below
will light. When none are lit this indicates i.LINK
is selected
nothing lit – An i.LINK signal is selected.
ANALOG : Lights when an analog signal is
selected.
DIGITAL : Lights when a digital signal is selected.
2RF : Lights when an 2 RF signal is selected.
AUTO : Lights when the amplifier is set to select
the input signal automatically.
2 Program Format indicators
For Dolby Digital, MPEG or DTS sources :
These indicators change according to which
channels are active in the source. When all
three LS (left surround), S (surround) and RS
(right surround) light at the same time it means
a source with a 6.1ch playback flag is being
used.
L – Left front channel.
C – Center channel.
R – Right front channel.
LS – Left surround channel.
S – Surround channel (mono).
RS – Right surround channel.
LFE – Low frequency effects channel.
3 ((( ))) – Lights when LFE signal is input.
4 Analog level indicators
OVER – This lights if the signal is in danger of
distorting for analog source signals. Press
INPUT ATT on the front panel to lower the
signal level.
DIGITAL
PRO LOGIC
2ch PLAYBACK
MPEG
DISC MTRX
Neo :6
OVER ATT
RF ATT
SP AB
L
LFE
TAPE 2
C R
L S S R S
3
SIGNAL
AUTO
RF
DIGITAL
ANALOG
1
9
2 5 6 3 4
7 8
Displays & Controls