Pioneer VSA-AX10 - Manual (Page 42)

42
En
9
2.1. Speaker Systems
Manual Free
” Normal Surround ”
FRONT [ LARGE ]
CENTER [ LARGE ]
SURROUND [ LARGE ]
SURR BACK [LARGE X 2]
SUB WOOFER [ YES ]
( NEXT)
3,4
2.1. Speaker Systems
Manual Free
Speaker System Select
[ Normal Surround ]
( Next)
2.1. Speaker Systems
Manual Free
” Normal Surround ”
Crossover [ 80Hz ]
Normal Surround
(THX Speaker = 80Hz)
Speaker B : Secound Zone
[Return]
Setting Up for Surround Sound
2 Use the
5∞ buttons to select the
speaker system setting and press ENTER.
Choose from:
MANUAL FREE: Sets all the speakers
MANUAL THX: All speakers are set to SMALL. You can
select only the number of surround back speakers.
AUTO: All speakers are set automatically. (The micro-
phone must be hooked up to the front panel in order to
use this setting.)
For MANUAL FREE, select it and press ENTER. Then go
to step 3.
For MANUAL THX, select it and press ENTER. Then go
to step 5.
For AUTO, select it and press ENTER. Be prepared for
loud test tones and make sure the room is free of ambient
noise (see memo page 16). When you see OK on the OSD
the setup is finished. Go to step 9.
3 Use the
2 3 buttons to select either
NORMAL SURROUND or FRONT BI-
AMP (5.1).
NORMAL SURROUND: For normal home theater use.
FRONT BI-AMP (5.1): Settings for bi-amp (see p.73).
4 Use the
∞ button to go to the next
screen.
If you selected AUTO in step 2 press ENTER. Make sure
the room is free of ambient noise (see memos on page 16)
and be prepared for loud test tones. If you are ready to
start select START and press ENTER. When you see OK
on the OSD the setup is finished. Go to step 9.
5 With the
5∞ buttons choose the set of
speakers that you want to set.
If you selected MANUAL THX in step 2, you can choose
only surround back.
If you selected FRONT BI-AMP (5.1) in step 3 you can’t
choose surround back.
6 Use the
2 3 buttons to choose the size
and number for each set of speakers as
well as LARGE, SMALL, YES, NO or PLUS.
7 Repeat steps 5 & 6 for all speakers
channels.
8 Use the
∞ button to go to the next screen.
9 Use the
2 3 buttons to choose a
Crossover Frequency of 50 Hz, 80 Hz,
100 Hz, 150 Hz or 200 Hz.
Certain bass sounds will play back from the subwoofer if
you selected it as YES (or PLUS) or from the other
speakers if you selected them as LARGE.
This setting decides where the cutoff will be between
those bass sounds playing back from the speakers
selected as LARGE, or the subwoofer, and the bass
sounds playing back from those selected as SMALL. It
also decides where the cutoff will be for bass sounds in
the LFE channel.
If you selected MANUAL THX in step 2 the Crossover
Frequency is set to 80Hz and this screen doesn’t appear.
2
2.1. Speaker Systems
[
Manual Free ]
[Manual THX]
(all small)
[Auto]
[Return]
2.1. Speaker Systems
Manual Free
” Normal Surround ”
FRONT [ LARGE ]
CENTER [ LARGE ]
SURROUND [ LARGE ]
SURR BACK [LARGE X 2]
SUB WOOFER [ YES ]
( NEXT)
7
5