Pioneer VSA-AX10 - Manual (Page 85)

85
En
Advanced Setup
EXPER
T
Assigning the Digital Inputs
If you did not hook up your digital equipment in accordance with the default settings for the digital inputs
(see p.19, 24 & 25) you need to complete the procedure below. You have to do this in order to tell the
amplifier what digital equipment is hooked up to which terminal so the buttons on the remote correspond
to what you have hooked up.
1 Turn on the amplifier and your TV,
press the AMP on the remote
control.
2 Press the SUB button on the remote
control.
3 Press the SYSTEM SETUP button.
4 Looking at the on-screen display on
your TV, use the
5∞ buttons to
select INPUT ASSIGN. Press the
ENTER button.
5 DIGITAL-IN SELECT should be
selected, if not use the
5∞ buttons
to select it. Press the ENTER button.
6 Use the
5∞ buttons to move
through the different digital input
settings and use the
2 3 buttons to
select the component that you
hooked up to that digital in.
7 If you're not sure which component
is connected to which digital in, look
on the back of the amplifier and
check the cables you connected.
8 When you're finished use the
5∞
buttons to select RETURN and press
ENTER.
You will leave the "Assigning the Digital Inputs" mode.
9 Use the
5∞ buttons to select
RETURN and press ENTER, again.
Then, use the
5∞ buttons to select
EXIT and press ENTER.
STATUS SPEAKER
A/B
LOUDNESS
INPUT
ATT.
Amplifier MAIN SUB
SIGNAL
SELECT
TAPE 2
MONITOR
SYSTEM
SETUP
DISPLAY
DIMMER
VIDEO
SELECT
EFFECT/
CH SEL.
BASS/
ATREBLE
TONE
AMP
DVD/LD
VCR1
/DVR
VCR2
VCR3
TV
REMOTE
SETUP
CD-R/
TAPE1
CD
TUNER
VIDEO
SAT
TV
CONTROL
1
2
3
4
5
6
System Setup
[ Auto Surround Setup ]
[ 1. Input Assign ]
[2. Surround Setup]
[3. Expert Setup]
[4. THX Audio Setup]
[Exit]
1.Input Assign
[ 1.Digital-In ]
[ 2.Component Video In ]
[ 3.i.LINK Input ]
[Return]
memo
• The possible digital inputs that can be as-
signed are: DVD/LD, TV, SAT, VCR 1/DVR,
VCR 2, VCR 3, CD, CD-R/TAPE 1/MD (except
for a 2 RF input which doesn't include CD,
CD-R/TAPE 1/MD).
• If you assign a digital input to a certain func-
tion (for example DVD/LD) then any digital
inputs previously assigned to that function will
automatically be set to OFF. This is because
one function cannot be assigned to two dif-
ferent places. The RF IN, however, is not af-
fected by this.
1.1. Digital-In
Digital-1 [ DVD/LD ]
Digital-2 [ TV ]
Digital-3 [ CD ]
Digital-4 [ SAT ]
Digital-5 [ VCR1 ]
Digital-6 [ VCR2 ]
Digital-7 [ CD-R ]
RF IN [ DVD/LD ]
[Return]