Pioneer VSA-AX10 - Manual (Page 67)

67
En
Remote Control of Other Components
BASIC
6 Press the number 1 button.
If the component you are trying to control turns on/off,
the setup for this component is complete, but compo-
nents that don't have a standby mode can't respond in
this way. To test if you've set it up properly work
through step 8. Then try using selecting the function
you just setup (for example a CD player) and using the
controls on this remote control. If the component does
not respond, try working through the procedure again
and pressing number 2 instead this time. Continue this
procedure until one of the commands works.
If none of the commands seem to work, try the
learning mode to program the component into the
remote control. This is explained on the following
page.
To go back a screen
press the BACK button.
To exit the process without inputting the com-
mands
press the BACK button repeatedly.
7 Press the SETUP OK button and the
screen returns to SELECT FUNCTION
so you can program another
component into the remote control.
Naturally it's easiest and most logical to assign the
button that has the same name as the component you
are setting up (for example, choose the DVD/LD button
for your DVD player).
You may find you have components which do not
correspond to the name on any MULTI CONTROL
button (for example a cable TV tuner) or you have two
components where only one button is provided (for
example, CD-R/TAPE 1). In this case, use step 3 to
assign any available MULTI CONTROL button to the
component you want to remote control.
For example, you may have both a CD-R and a tape
deck in your system but only one video deck. It would
make sense to assign the CD-R/TAPE 1 MULTI
CONTROL button to the CD-R and the VCR 2 MULTI
CONTROL button to your tape deck. To do this choose
VCR 2 in step 3 when you want to set up the tape
deck. Then choose TAPE in step 4 and proceed as
above. The only practical difference in this method is
that you have to remember the VCR 2 MULTI CON-
TROL button is actually your tape deck.
In this case, you would need to hook up your tape
deck to the input jacks marked VCR 2 on the back of
the amplifier.
This method should help you customize the remote
control for your system and let you control all of your
components with the remote control for the VSA-
AX10-S.
8 Repeat the process from step 2 for
all of your components.
9 Press the BACK button repeatedly to
leave the REMOTE SETUP mode.
5
6
7
«
AMP
DVD/LD
VCR1
/DVR
VCR2
VCR3
TV
REMOTE
SETUP
CD-R/
TAPE1
CD
TUNER
VIDEO
SAT
TV
CONTROL
Preset Recall
PAGE
1 / 2
PIONEER TOSHIBA
ITEM
SELECT MAKER
MAKER
SHARP
SONY
PANA-
SONIC
SAM-
SUNG
DVD
PIONEER AKAI DENON VICTOR
BACK DVD/LD] [
AMP
DVD/LD
VCR1
/DVR
VCR2
VCR3
TV
REMOTE
SETUP
CD-R/
TAPE1
CD
TUNER
VIDEO
SAT
TV
CONTROL
Preset Recall
ITEM SELECT NUMBER
MAKER
DVD
PIONEER
NUMBER
1
SETUP
OK
BACK DVD/LD] [
1 2
AMP
DVD/LD
VCR1
/DVR
VCR2
VCR3
TV
REMOTE
SETUP
CD-R/
TAPE1
CD
TUNER
VIDEO
SAT
TV
CONTROL
Preset Recall BACK
SELECT FUNCTION
9