Pioneer VSA-AX10 - Manual (Page 93)

93
En
Advanced Setup
EXPER
T
MULTI CH IN SELECT
Use this feature to adjust the type of output for audio signals which were input from MULTI CH INPUT
terminals. You can set the output of the audio signal in regards to the surround speakers and the surround
back speakers, which were input from 5.1 channel surround sound soundtrack.
There are three OUTPUT MODE settings:
THROUGH: the sound is output directly how it was input.
S
=SB: The audio signal which was input into the surround channels will be output from the surround
back speakers only.
S
=S & SB: The audio signal which was input into the surround channel is output from the surround
speakers and from the surround back speakers. This setting will give the most realistic home theater
experience in the MULTI CH IN SELECT setting if you don't connect surround back inputs.
Follow steps 1-4 on page 89, if necessary, to get to the
starting point mentioned here.
1 MULTI-CH IN SELECT should be
selected if it isn’t use the
5∞ buttons
to select it. Press ENTER.
2 Use the
2 3 buttons to select surround
back input: YESx2 ( ), YESx1 ( ) or
NO ( )
You do this to establish the proper downmixing of sur-
round back channels. If you connected two surround back
inputs choose YESx2. If you connected one surround back
input choose YESx1. And if you connected no surround
back inputs choose NO.
3 Use the
5∞ buttons to select the
OUTPUT MODE you want.
See the OUTPUT MODE explanations above. For details
on speaker placement in this mode see page 103.
4 Use the
2 3 buttons to choose a type
of output mode: THROUGH, S
=SB,
S
=S & SB.
5 Use the
5∞ buttons to select RETURN.
Press ENTER.
Your MULTI CH IN SELECT output set. Next, move on to
FUNCTION RENAME, if necessary.
If you want to change a setting before proceeding
Start over from step one.
6 If you want to continue EXPERT SETUP
use the
5∞ buttons to select the next
setup and press ENTER.
Go on to the next page.
7 If you want to finish EXPERT SETUP
use the
5∞ buttons to select RETURN
and press ENTER. Then use the
5∞
buttons to select EXIT and press
ENTER.
3.4. Multi-Ch In Select
Surround Back Input
[
Yesx2 ]
Output Mode
[Through]
[Return]
3.Expert Setup
[1. OSD Adjustment ]
[2. Bass Peak Level ]
[3. D-Range Control ]
[
4. Multi-Ch In Select ]
[5. Function Rename ]
[6. Hi-bit/Hi-sampling ]
[Return]
3.4. Multi-Ch In Select
Surround Back Input
[Yesx2]
Output Mode
[
S SB ]
[Return]
2
3,
4,5
1
memo • If you want to setup either S
=SB,
S =S & SB, you need to connect
all 7.1 CH speakers, including the
surround back left and right speak-
ers.
• If you use only one surround back
speaker hook it up to the left sur-
round back speaker terminal.
ENTER
STANDBY/ON
5˜∞˜2˜3˜ENTER buttons