Pioneer VSA-AX10 - Manual (Page 53)

53
En
BASIC
Playback of up to 192kHz, 24-bit sound formats
This amplifier is capable of playing back 96kHz/24bit sound formats (such as DTS 96/24 and PCM 96kHz up to
24bit). In addition, when connected to an i.LINK-equipped component, playback of up to 192kHz, 24-bit sound
formats (such as DVD-A) or an SACD is supported.
To Playback with the Best Sound Quality (all processing is done without down sampling).
For 192kHz format, choose STEREO mode and turn off sound functions. For DTS 96/24 5.1 format, connect
both center and surround left/right speakers, choose STANDARD mode (If you select 7.1 in LISTENING CH
SELECT, choose STANDARD SX mode.) and turn off all sound functions. For 96kHz 2ch format (either DTS or
PCM) choose STEREO mode and turn off sound functions.
Although you should turn off all sound functions, TONE CONTROL may still be used.
You can listen to DTS 96/24 soundtracks through this amplifier if your DVD player has a DTS output feature,
even if it can't output 96kHz digital signals. For PCM 192/96kHz soundtracks (including DVD-A), however, you
won't be able to listen to them with digital connections if your DVD player can't output 192/96kHz digital signals.
Also, if you set DYNAMIC RANGE CONTROL (see p.92) on, playback will be downsampled.
Check the manual that came with your DVD player to confirm what it can output and for more information on
these formats.
Listening Modes
The five listening mode types on the amplifier are explained here. These can be turned on from the front panel
or from the AMPLIFIER MAIN screen on the remote control. To select listening modes see p.50-51
.
The kind of playback you can get in the threse listening modes depends on what kind of source (DVD, etc.) you
are using. The basic distinction is between 2 channel sources and multichannel sources. The playback available
to you with these modes will differ depending on the source, speaker configuration the LISTENING CH SELECT
setting. This is explained below.
Basically the ADVANCED CINEMA mode is for movie sources and the ADVANCED CONCERT mode is for music
sources. The STANDARD, HOME THX and STEREO modes can be used with any source though the latter won't
offer surround sound. Try different settings with various soundtracks to see which you like.
You must choose one of the surround modes in order to get surround sound. Depending on your setup, in
STEREO mode only the front two speakers, and sometimes the subwoofer (if you have one), are used.
STEREO modes
When a source is played in this mode, it plays through just the front left and right speakers (and possibly your
subwoofer depending on your speaker settings). Dolby Digital, MPEG and DTS and some DVD-A and SACD
multichannel sources are downmixed to stereo.
STEREO
In STEREO mode the audio plays according to the surround setup settings and you can still use Acoustic
Calibration EQ, Digital NR, Midnight mode, Loudness mode and Tone Control functions.
DIRECT
In DIRECT mode, the audio passes through the shortest signal path possible to remain as close to the source
audio quality as possible.
Note: If you switch on Acoustic Calibration EQ, Digital NR, Midnight mode, Loudness mode or Tone Control
when DIRECT is selected, the amplifier automatically switches to STEREO. And, during playback of a 2
channel DVD-A or 2 channel SACD the listening mode is automatically fixed on STEREO or DIRECT.
Basic Operation
memo