Pioneer LX03 - Manual (Page 27)

Listening to your system 05
27
En
Engli
sh
Françai
s
Deut
sc
h
Ne
d
erlan
ds
Italiano
E
spañol
Chapter 5
Listening to your system
Important
• This unit’s audio function may be restricted
depending on the sound source, Line
Output setting (page 60), and HDMI audio
setting (page 63). In this event, the menus
may not appear, or a message may be
displayed instead (page 83).
Auto listening mode
The Auto listening mode is the simplest way to
listen to any source as it was mastered: the
output from the speakers mirrors the channels
in the source material.
• If you set up the system for Front surround
(page 7), the Front Stage Surround modes
will give the best results (page 28).
• Press to select the Auto listening
mode. 1
• When playing stereo sources, the STEREO
indicator will light. The 2D indicator will
light when playing a Dolby Surround sound
source.
Listening in surround sound
You can listen to stereo or multichannel
sources in surround sound. Surround sound is
generated from stereo sources using one of
the Dolby Pro Logic decoding modes.
• If you set up the system for Front surround
(page 7), the Front Stage Surround modes
will give the best results (page 28).
• Press repeatedly to select a
listening mode. 1
The choices that appear in the display will vary
according to the type of source that’s playing.
With two channel sources, you can select from:
• Auto – See Auto listening mode above
• 2PL II Movie (Dolby Pro Logic II Movie) 2
– 5.1 channel surround sound, especially
suited to movie sources
• 2PL II Music (Dolby Pro Logic II Music) 2 –
5.1 channel surround sound, especially
suited to music sources; see Dolby Pro
Logic II Music settings below
• 2Pro Logic (Dolby Pro Logic) 2
– 4.1
channel surround sound for use with any
two-channel source
• Stereo – See Listening in stereo on page 29
• A.L.C. – See Listening in stereo on page 29
With multichannel sources, you can select
(according to format):
• Auto – See Auto listening mode above
• Stereo – See Listening in stereo on page 29
• A.L.C. – See Listening in stereo on page 29
Dolby Pro Logic II Music settings
When listening in Dolby Pro Logic II Music
mode (see above), there are three settings you
can adjust: Center Width, Dimension, and
Panorama.
1 Press when Dolby Pro Logic II Music
mode is active.
Note
1 • If the source is Dolby Digital or DTS, the corresponding indicator lights in the front panel display.
• During 88.2 kHz/96 kHz source playback, the listening mode is fixed to Auto and cannot be changed.
SURROUND
2 The 2PL II indicator will light.
SURROUND
SOUND
LX03_En.book 27 ページ ２００８年６月２４日 火曜日 午後６時１分