Other connections 12, Listening to an external audio source, Connecting external antennas – Pioneer LX03 User Manual
Page 61
Other connections
12
61
En
Engli
sh
Françai
s
Deut
sc
h
Ne
d
erlan
ds
Italiano
E
spañol
2
Select ‘Sound Setup’, then press
ENTER.
3
Select ‘Line Output’, then press
ENTER.
4
Select a setting.
Select one of the following:
• Lo/Ro(Stereo) – A simple stereo downmix
(left-only/right-only, or Lo/Ro) is output
(suitable for playback on a two-channel
stereo system or on headphones).
• Lt/Rt – A surround-compatible downmix
(left-total/right-total, or Lt/Rt) of Dolby
multichannel sources is output, (suitable
for Dolby Surround Pro Logic or other
matrix decoding).
The L.OUT indicator lights.
5
Press to exit.
Listening to an external audio
source
To listen to audio from a connected external
component on this system, choose its input
function on the remote control. Some Pioneer
products can be controlled via this remote.
1
If the system isn’t already on,
switch it on.
Also make sure that the external source (TV,
satellite receiver, etc.) is switched on.
2
Select an audio input source.
Input sources are cycled through as shown
below:
3
If necessary, start playback of the
external source.
Connecting external antennas
For an external AM antenna, use 5 to 6 meters
of vinyl-insulated wire and set up either indoors
or outdoors. Leave the loop antenna
connected.
For an external FM antenna, use a PAL
connector to hook up an external FM antenna.
ENTER
ENTER
ENTER
STANDBY / ON
LINE
Digital 1 OPT
Digital 2 OPT
Digital 3 COAX
Analog 1 RCA
Analog 2 SCART
DIGITAL IN
ANTENNA
OPTICAL
AM
LOOP
FM
UNBAL
75
2
1
Outdoor antenna
External AM antenna
AM Loop antenna
(5 m to 6 m)
Indoor antenna
(vinyl-coated Wire)
External
FM antenna
PAL connector
LX03_En.book 61 ページ ２００８年６月２４日 火曜日 午後６時１分