Pioneer DVH-P5000MP - Manual (Page 63)

Introduction of DSP
adjustments
Important
Following functions are effective only when you
connected a Pioneer multi-channel processor
(DEQ-P7000) to this unit.
By carrying out the following settings/adjust-
ments in order, you can create a finely-tuned
sound field effortlessly.
1 Setting the speaker setting
2 Using the position selector
3 Adjusting the time alignment
4 Adjusting the speaker output levels using a
test tone
5 Selecting a cut-off frequency
6 Adjusting the speaker output levels
7 Adjusting 3-band parametric equalizer
Operating the DSP menu
1
2
1 DSP display
Shows the DSP status.
2 Subwoofer indicator
Shows when the subwoofer output is turned
on.
% Press A to display the DSP function
names.
Press A repeatedly to switch between the fol-
lowing DSP functions:
POSI (position selector)FAD (balance ad-
justment)SLA (source level adjustment)
DRC (dynamic range control)DMONO
(dual monaural)DIRECT (direct)PL (Dolby
Pro Logic)
# When selecting the FM tuner as the source,
you cannot switch to SLA, DRC, DMONO.
# When playing other than the DVD disc, you
cannot switch to DRC or DMONO.
# To return to the display of each source, press
BAND.
Note
If you do not operate the DSP function within
about 30 seconds, the display is automatically re-
turned to the source display.
Operating the DSP details menu
1
1 DSP display
Shows the DSP status.
% Press A and hold until FRONT appears
in the display, then press A to display the
DSP function names.
After FRONT is displayed, press A repeatedly,
the following DSP functions appear in the dis-
play:
FRONT (speaker setting)HPF (cut-off fre-
quency)FRT-L (speaker output level)
T TONE (test tone)FL (time alignment)
PEQ (3-band parametric equalizer)
# When neither F/L nor F/R is selected in POSI,
you cannot switch to FL.
# When neither CUSTOM1 nor CUSTOM2 is se-
lected as an equalizer curve, you cannot switch
to PEQ.
# To return to the display of each source, press
BAND.
Digital Signal Processor
En
63
English
Section
13