Pioneer DVH-P5000MP - Manual (Page 66)

Using the dual mono mode
When playing a disc recorded on a dual mono
mode, you can select the channel to output.
! This function is effective only on dual mono
mode sound.
1 Press A to select DMONO.
Press A until DMONO appears in the display.
# When playing other than the DVD disc, you
cannot switch this mode.
2 Press m or n to select the desired
output setting.
Each press of m or n selects output set-
ting in the following order:
L+R (left and right channels)L (left channel)
R (right channel)
Using the direct control
You can override audio settings to check for ef-
fectiveness of your audio settings.
1 Press A to select DIRECT.
Press A until DIRECT appears in the display.
2 Press r to turn the direct control on.
DIRECT:ON appears in the display. Direct con-
trol is now on.
# To turn direct control off, press q.
Notes
! All audio functions are locked out during
DIRECT:ON except VOLUME.
! If the source is a 2-channel LPCM audio or a
2-channel Dolby Digital audio and you select
DIRECT:ON, audio is heared only over front
left/right speakers.
Using the Dolby Pro Logic
Dolby Pro Logic gives enhanced spatial and di-
rectional effects, creating theater-like sense of
presence and ambience.
! If the source is a 2-channel LPCM audio or
a 2-channel Dolby Digital audio and you se-
lect SFC effects that are most applicable
for 5.1-channel audio (i.e., MUSICAL,
DRAMA or ACTION), we recommend turn-
ing Dolby Pro Logic on. On the other hand,
when selecting SFC effects that are in-
tended for use with 2-channel audio (i.e.,
JAZZ, HALL or CLUB), we recommend turn-
ing Dolby Pro Logic off.
1 Press A to select PL.
Press A until PL appears in the display.
2 Press r to turn the Dolby Pro Logic
on.
PL :ON appears in the display. Dolby Pro Logic
is now on.
# To turn Dolby Pro Logic off, press q.
Note
When playing a 2-channel mono source with Pro
Logic turned on, there may be occasions when
the following will occur:
! No audio is output if the center speaker set-
ting is SML or LRG and no center speaker is
installed.
! Audio is heard only over the center speaker if
installed and the center speaker setting is
SML or LRG.
Digital Signal Processor
En
66
Section
13