Pioneer DV-989AVi-S - Manual (Page 12)

Connecting up 02
12
En
Chapter 2
Connecting up
Rear panel
When connecting this player up to your TV, AV
receiver or other components, make sure that
all components are switched off and
unplugged.
1 AUDIO OUT (2ch)
Two channel analog audio outputs for
connection to your TV, AV receiver or stereo
system (page 14,18).
2 AUDIO OUT (5.1ch)
Multichannel analog audio outputs for
connection to an AV receiver with
multichannel inputs (page 17).
3 DIGITAL AUDIO OUT – OPTICAL /
COAXIAL
Digital audio outputs for connection to a
PCM, Dolby Digital, DTS and/or MPEG-
compatible AV receiver (page 18).
4 AV CONNECTOR
AV CONNECTOR 1 (RGB)-TV/AV
Receiver
Use a 21-pin SCART cable to connect to a
TV or monitor compatible with this type of
connection. Both audio (2 channel stereo)
and video (Video, S-video, and RGB)
signals are output from the
AV
CONNECTOR 1 (RGB)-TV (page 15).
AV CONNECTOR 2
Use a 21-pin SCART cable to connect to a
VCR (page 15).
5 AC IN
Connect the supplied power cord here, then
plug into a power outlet. Refer to the
illustration below when doing so to make sure
the neutral and live blades are lined up
properly.
AV CONNECTOR 1 (RGB)-TV/AV Receiver AV CONNECTOR 2
OPTICAL COAXIAL
R
L
R
L
SUB WOOFER AUDIO OUT (2ch)
CENTER SURROUND FRONT
AUDIO OUT (5.1ch)
DIGITAL AUDIO
OUT
(AUDIO) HDMI OUT
S400
2 1 2 1
VIDEO OUT S-VIDEO OUT COMPONENT VIDEO OUT CONTROL
IN OUT P B P R Y
AC IN
1 2 3 4 5
11 10 8 9 6 7
LIVE NEUTRAL N : Neutral
L : Live
AC IN
N L
Power cord
DV-989_en.book Page 12 Monday, July 25, 2005 7:37 PM