Pioneer DV-989AVi-S - Manual (Page 93)

Additional information 09
93
En
English
The analog audio is OK, but
there appears to be no
optical/coaxial digital audio
signal. • Make sure that the Digital Out setting is set to On (see Digital Out
on page 61).
• Check that the
Dolby Digital , DTS and MPEG Out settings (see
Digital Audio Out settings on page 61) are suitable for your amplifier/
receiver—check the instruction manual that came with your
amplifier/receiver.
• SACDs and some DVD-Audio discs do not output digital audio.
Listen through the player’s analog audio outputs.
• Check that the
PURE AUDIO indicator is not lit. If it is, press the
PURE AUDIO button ( See also Front panel on page 24).
Noticeable difference in
DVD and CD volume. • This is due to differences in the audio format and is not a
malfunction.
Cannot play multi-channel
audio. • Make sure that Audio Output Mode is set to 5.1 Channel (see
Audio Output Mode on page 75).
• Check that the Dolby Digital , DTS and MPEG Out settings (see
Digital Audio Out settings on page 61) are suitable for your amplifier/
receiver—check the instruction manual that came with your
amplifier/receiver.
• DVD-Audio and SACDs do not output multichannel digital audio.
Listen through the player’s analog outputs.
• Check that the settings in the
Speaker Installation on page 75 are
correct.
• Check the audio options available from the disc menu.
Cannot listen to high-
sampling rate audio
through the optical/coaxial
digital output. • Make sure that Linear PCM Out is set to Down Sample Off (see
Linear PCM Out on page 62).
• As a copy-protection measure, some DVDs do not output 96kHz
audio. In this case, even if set to
Down Sample Off , the player
automatically outputs the audio at 48 kHz. This is not a malfunction.
Cannot output 192kHz or
176.4kHz digital audio from
optical/coaxial output. • The player does not output digital audio from the optical/coaxial
jacks at these sampling rates. The digital output is automatically
downsampled.
Cannot output 96kHz or
88.2kHz digital audio from
optical/coaxial output. • Check that Linear PCM Out is set to Down Sample Off
(see Linear PCM Out on page 62).
• Some discs are digital copy protected and do not output high
sampling rate digital audio. In this case the output is automatically
downsampled.
No DTS audio output from
optical/coaxial output. • If this unit is connected to a non-DTS compatible amplifier or
decoder using a digital audio cable, set
DTS Out to DTS > PCM . If you
do not do this, noise will be output when you play a DTS disc.
• If this unit is connected to a DTS-compatible amplifier or decoder
using a digital audio cable, check the amplifier settings, and that the
cable is properly connected.
Problem Remedy
DV-989_en.book Page 93 Monday, July 25, 2005 7:37 PM