Toshiba Magnia 3310 - Manual (Page 199)

Installing Software
Windows® 2000 Server 182
Selecting the disk driver
Selecting the IDE CD-ROM Controller driver
No special operations are required as the driver contained on the
CD-ROM of the Windows 2000 Server is used.
Selecting a driver for the RAID controller
Only when the RAID controller is connected, follow the
procedure mentioned below.
1 When the Windows 2000 Server Setup screen appears and
"Press F6..." is displayed in the lower left hand corner of the
screen, press the F6 key.
2 When a message appears on the screen, asking whether you
want to add a device driver for mass storage device, press the
<S> key.
3 Insert the Windows 2000 driver floppy disk of RAID control-
ler, which comes with your RAID controller, in the floppy disk
drive, and then press the <Enter> key.
4 When the list of drivers appears, select the driver for each
RAID Controller, according to the following procedure.
5 For RAID Controller MR520, select “MegaRAID SCSI 320-1
Controller Driver” and then press the <Enter> key.
6 For RAID controller MR518, select “MegaRAID SCSI 320-2
Controller Driver”, and then press the <Enter> key.
After this, continue to install Windows 2000, following the
instructions that appears on the screen.
MegaRAID SCSI 320-1 Controller Driver
MegaRAID SCSI 320-2 Controller Driver