Service – Bunn -O-MATIC ULTRA-1 User Manual
Page 22
22
SERVICE
This section provides procedures for testing and replacing various major components used in this dispenser
should service become necessary. Refer to Troubleshooting for assistance in determining the cause of any
problem.
WARNING - Inspection, testing, and repair of electrical equipment should be performed only by qualified service
personnel. The dispenser should be disconnected from the power source when servicing, except when electrical
tests are required and the test procedure specifically states to connect the dispenser to the power source.
COMPONENT ACCESS PANELS
WARNING - Disconnect the dispenser from the power source before the removal of any panel or the replacement
of any component.
All components are accessible by removal of the auger motor cover, lower drip tray, front cover and the left
and right side covers.
Refer to the contents listing for component location.
P3930.30
41084 102709