Bunn -O-MATIC ULTRA-1 - Manual (Page 41)

41
SERVICE (cont.)
COOLING DRUM ALIGNMENT
The “A” shaped Cooling Drum Shipping Supports,
removed during Initial Set-Up should be kept and used
as a tool to reset the alignment of the cooling drums
should it ever be required.
Symptoms:
Squeaky Operation, hopper lifts or won’t seat properly,
hopper is pushed to one side or the other.
To check alignment
1. Place the “A” shaped support on the auger shaft
with the ledge under the cooling drum.
2. Lift the cooling drum while rotating the support into
a vertical position. The boss on the very bottom will
drop into the hopper drip tray’s drain hole.
Ledge
Boss
Legs
When in its proper position, the cooling drum will cause
a slight pressure on the hopper drip tray drain hole
and the two legs will be equidistant from the hopper
drip tray.
If adjustment is needed, remove the support and gently
force the free end of the evaporator in the direction the
adjustment is needed.
Reinstall the support, check the alignment, and readjust
the cooling drums as required.
Never try to remove the cooling drums (4 screws)
unless trained refrigeration technician is replacing
the evaporator assembly.
P1510
FIG. 37 COOLING DRUM SHIPPING SUPPORT
FIG. 38 CHECKING ALIGNMENT
Drain Hole
Drip Tray
41084 102709