Brady 200M User Manual
Page 16
Media
Media Specifications
200M
260M
Total media width
Maximum
4.5"
115 mm
7.2"
182.9 mm
Minimum
0.75"
19 mm
2.0"
50.8 mm
Label
length
Maximum
Refer to “ Printing Considerations” on page 1-6.
Minimum
Tear-Off
0.5"
12.8 mm
0.63"
16.00 mm
Peel-Off
0.5"
12.8 mm
0.75"
19.05 mm
Rewind
0.5"
12.8 mm
0.75"
19.05 mm
Total
thickness
(includes
liner)
Maximum (Printhead
position may need to be
adjusted above 0.01")
0.012"
0.304 mm
0.012"
0.304 mm
Minimum
0.0023"
0.058 mm
0.0023"
0.058 mm
Core size
3.0"
75 mm
3.0"
75 mm
Maximum roll diameter
8.0"
203 mm
8.0"
203 mm
Interlabel gap
(0.115"/3 mm preferred)
0.079" - 0.157"
2 - 4 mm
0.079" -
0.157"
2 - 4 mm
Maximum internal fanfold media pack
size (L x W x H)
8.0" x 4.5" x
6.2"
203 x 105 x
158 mm
8.00" x
7.2" x 6.2"
203 x 183 x
158 mm
Additional Specifications for Black-Mark Media*
Mark thickness
(measuring parallel to
label/tag edge)
Minimum
0.12"
3 mm
0.12"
3 mm
Maximum
0.43"
11 mm
0.43"
11 mm
Mark width (measuring
perpendicular to
label/tag edge)
Minimum
0.43"
11 mm
0.43"
11 mm
Maximum
Full media width.
Full media width.
Mark-to-mark leading edge registration
tolerance
+ /- 0.016"
+/- 0.4 mm
+/- 0.016"
+/- 0.4 mm
Mark location
Mark is recommended to be
located on the inside of the media
(closest to the printer’s mainframe
when loaded in the printer). If
mark is located elsewhere, test for
your application.
Marks must be located on
the inside of the media
(closest to the printer’s
mainframe when loaded in
the printer).
Mark density
> 1.0 ODU (Optical Density Unit)
Density of the back of the media on
which the black mark is printed
0.5 ODU maximum
* The 200M can be field-equipped with an optional reflective (black-mark) media sensor which replaces
the factory-installed transmissive sensor. The black-mark media specifications shown for the 200M require
that the optional reflective sensor kit be installed.
In
tr
o
d
u
ct
io
n
M-Series User s Guide
Introduction
1-7