Brady 200M - Manual (Page 95)

Loading Permasleeve
Load Permasleeve and Brady 4300A or 4300 ribbon as instructed
in chapter 2. The Permasleeve roll should be loaded on the
spindle such that:
•
One-sided Permasleeve: Printable area of sleeves is face-
up.
•
Two-sided Permasleeve: Permasleeve side not constricted
by two strips of adhesive tape is face-up for first-side
printing.
Note: Permasleeve must be positioned such that the rectangular
registration holes punched in the Permasleeve carrier are to
the inside of the printer (towards the fire wall).
Note: Permasleeve may be run directly out of the box through the
slot located in the back of the pritner, or it can be placed on
the media spindle located within the printer. A large roll of
Permasleeve should be run directly out of the box to
prevent it from rubbing against the printer housing.
Figure F.2 Permasleeve Positioning
Appendix F - Permasleeve Printing M-Series User ’s Guide
F-2