Brady 200M User Manual
Page 69
Advertising
9. Pull the media out of the printer until a label is positioned un-
der the Printhead. Move the ribbon back to its normal posi-
tion.
Note: Be sure that label is positioned between the upper and
lower Media Sensors.
10. Close the Printhead.
11. Press the MODE key to print a Media and Sensor Profile and
save the new values. (See Figure 7.4.)
12. Perform the Media Calibration procedure in chapter 4.
Figure 7.6 Media Sensor Profile Sample Printout
Adjustments
M-Series User s Guide
7-8
Advertising
This manual is related to the following products: