Brady 200M User Manual
Page 66
Upper Transmissive Media Sensor Position Adjustment
To adjust the upper media sensor to accommodate
non-Brady-brand media, refer to Figure 7.2 and follow these steps.
1. Remove the ribbon and locate the Upper Media Sensor.
2. Loosen the Phillips head screw.
3. Slide the upper sensor along the slot to the desired position.
When using media that has a web between labels, position the
media sensor anywhere along the web (except if you have labels
with rounded corners, do not position the sensor where the
rounded corners of the label might be detected). When using tag
stock, position the upper sensor directly over the hole or notch.
4. Tighten the Phillips head screw.
260M only: To adjust the upper section of the Transmissive
Media Sensor for the outside half of the media width, call a
service technician.
A
d
ju
st
m
en
ts
M-Series User s Guide
Adjustments
7-5