SkyTrak 6036 Operation Manual - Manual (Page 124)

118 Model 6036
General Maintenance
B. Change Fuel Filter
(500 Hour Intervals)
The fuel filter must be changed at shorter intervals with evidence of water or
contaminated fuel.
1. Unlock and open the right rear engine access door.
2. Clean around the fuel filter head (Figure 73, 1).
3. Unscrew the fuel filter (Figure 73, 2) and dispose of properly.
4. Clean the gasket surface of the filter head and replace the o-ring.
Figure 73
5. Fill the new fuel filter with clean No. 2 diesel fuel.
6. Lubricate the o-ring seal with clean No. 2 diesel fuel.
7. Install the fuel-filled filter and hand tighten. DO NOT overtighten.
NOTE: Mechanical over-tightening may distort the threads or damage the
sealing ring.
8. Close and lock the right rear engine access door.
Controlled venting is provided at the injection pump through the fuel drain
manifold. Small amounts of air introduced by changing the fuel filter element
will be vented automatically as long as the element was filled with fuel prior
to installation.
500
OS0870 OT1150
OH2200
1
2