SkyTrak 6036 Operation Manual - Manual (Page 56)

50 Model 6036
Operation
Cab Heater & Fan Control
(Figure 32)
The cab heater controls (Figure 32, 1) are located directly below the switch
banks on the right side dash panel. The control panel consists of: a variable
speed fan control knob (2) and a temperature control knob (3).
Control of air flow to the windshield is made by opening, closing or
redirecting the air vent louver on the front dash. The cab is heated by the
heater unit positioned under the operators seat.
To heat the cab:
• Turn temperature control knob (Figure 32, 3) to far right position
(RED = HOT),
• Direct desired air flow by adjusting vent louvers under the seat,
• Turn fan control (Figure 32, 2) to “3” to assure rapid warm-up.
To defrost the cab:
• Turn temperature control knob (Figure 32, 3) to the far right
position (RED = HOT),
• Direct desired air flow by adjusting vent louver on the front dash,
• Turn fan control (Figure 32, 2) to “3” to assure rapid defrost.
Figure 32
OS1950
OS1950
OA1390
3
OH1883
2
1