SkyTrak 6036 Operation Manual - Manual (Page 60)

54 Model 6036
Operation
The engine is equipped with a 120 volt 750 watt block heater. Block heaters
are recommended when temperatures drop below 10° F (-12° C).
(Temperature ranges will vary when using different oil weights. Consult the
engine manufacturer’s manual for other variables.)
At temperatures below 10° F (-12° C), operate the engine at moderate
speeds for 5 minutes before full loads are applied.
1. Enter the cab using the hand holds and adjust the seat for comfort-
able operation.
2. Adjust the mirrors to obtain the best rear view from the operator’s
position.
3. Fasten the seat belt.
4. Make sure the parking brake switch is ENGAGED.
5. Place the travel select lever in (N) NEUTRAL and move the neutral
lock lever to NEUTRAL LOCK position.
6. Turn the ignition switch to the START position to crank the starter.
IMPORTANT! DO NOT crank the starting motor continuously for more than
30 seconds. Stop cranking the starter and allow the starter to cool for 2
minutes before engaging the starter again.
7. As the engine starts, release the ignition switch to the RUN posi-
tion. Depress the accelerator pedal enough to provide a smooth
idle speed.
8. The engine oil pressure warning indicator light should go OFF
within five seconds after starting. If the light remains ON, turn the
ignition switch OFF immediately and check the oil level or change
to a lighter weight oil. Consult the engine manufacturer’s manual for
alternative oils for cold weather operation.
Cold Starting
WARNING:
DO NOT start the engine unless you are in the
seat with the seat belt fastened around you. Death or serious per-
sonal injury could result if the belt is not securely fastened.