SkyTrak 6036 Operation Manual - Manual (Page 67)

Operation
61 Model 6036
Figure 38
Shifting Gears
1. Rotate the twist grip of the gear select lever to the next desired
gear. The transmission has four forward gears and three reverse
gears.
2. Use first gear for highest torque and pulling power. Use higher
gears for higher ground speed. The recommendations listed in the
table that follows are guidelines only. Always use good judgement
when traveling with a load.
Recommended Gear/Speed for Various Load/Travel Conditions
*NEVER travel in 4th gear when carrying a load.
NOTE: Shifting to the next higher gear may be done while the vehicle is in
motion.
IMPORTANT! When downshifting, allow the engine speed to slow down
before shifting to the next lower gear.
Load Size Surface Gear Speed
No Load Smooth 4th* 0 to 20 mph (0 to 32 km/h)
Improved 3rd 0 to 14 mph (0 to 23 km/h)
Rough 2nd 0 to 6 mph (0 to 9,7 km/h)
Load Smooth 3rd 0 to 14 mph (0 to 23 km/h)
up to 3,500 lbs Improved 2nd 0 to 6 mph (0 to 9,7 km/h)
(up to 1.588 kg) Rough 2nd 0 to 6 mph (0 to 9,7 km/h)
Load Smooth 3rd 0 to 14 mph (0 to 23 km/h)
3,500 to 6,000 lbs Improved 2nd 0 to 6 mph (0 to 9,7 km/h)
(1.588 to 2.721 kg) Rough 1st 0 to 3.5 mph (0 to 5,6 km/h)
OH1792
1
2