SkyTrak 6036 Operation Manual - Manual (Page 142)

136 Model 6036
General Maintenance
A. Wheel End Oil Level
Check
(250 Hour Intervals)
1. Position the vehicle on level ground, move the vehicle forward or
backward enough to ensure that the lower edge of the wheel end
(Figure 89, 1) fill/drain plug hole (2) is positioned horizontally (3).
2. Ground the carriage, place the travel select lever in (N) NEUTRAL,
move neutral lock lever to NEUTRAL LOCK position, engage the
parking brake switch and shut off the engine.
3. Clean the area around the wheel end fill/drain plug (Figure 89, 2).
Slowly remove the plug. Check the oil level.
4. Add Universal Tractor Fluid to bring the oil level up and even with
the plug hole (Figure 89, 2). See the above chart for approved flu-
ids.
5. Clean and re-install the wheel end fill/drain plug (Figure 89, 2).
Figure 89
11. Wheel End Oil
WARNING:
DO NOT perform service or maintenance on
this vehicle with the engine running. Contact with moving parts
can cause death or serious personal injury.
APPROVED UNIVERSAL TRACTOR FLUIDS
JOHN DEERE
FORD / NEW HOLLAND
MASSEY FERGUSON
CHEVRON
JDM J20C (HY-GARD)
ESN-M2C134-D (HYDRAULIC OIL134)
M-1141 (PERMATRAN III)
CHEVRON 1000 THF
OT0430
250
OH2710
OA1330
1
2
3