SkyTrak 6036 Operation Manual - Manual (Page 52)

46 Model 6036
Operation
Turn Signals
(Figure 29)
The directional signals are ACTIVATED from the lever (Figure 29, 1) on the
right side of the steering wheel. To activate the left turn signal (2), raise the
lever. To activate the right turn signal (3), lower the lever. To deactivate
either directional signal, the lever must be manually returned to the center
position. The lever will not cancel automatically after a turn. These lights will
only operate when the ignition switch is in the RUN position.
Parking Lights, Headlights & High/Low Beam Switch
(Figure 29)
With the ignition switch in the RUN position use the turn signal switch
(Figure 29, 1) to control the high/low beam headlights, turn ON the parking
lights and the headlights. Turn the twist grip end (4) of the turn signal switch
counter-clockwise to the first position (5) to turn the parking lights ON. Turn
the twist grip to the second position (6) to turn the headlights and parking
lights ON. Turn the twist grip clockwise to the OFF position (7) to turn all the
lights OFF. Pull the turn signal switch toward you to switch from low beam to
high beam. When the high beam is ON the high beam indicator light will
illuminate.
Figure 29
OH2510
OH1872
2
3
7
5
6
1
4