SkyTrak 8042 Service Manual - Manual (Page 108)

Axles, Drive Shafts, Wheels and Tires
5-4 6036, 6042, 8042, 10042, 10054
5.3 GENERAL INFORMATION
Note: To help ensure optimum performance, the drive
shaft assemblies are specially balanced as a unit at the
factory. When servicing any flange yoke, slip yoke or
drive shaft tube, order a complete assembly if
components are bent or damaged. Refer to the
appropriate parts manual for ordering information.
Before performing any inspection, maintenance or
service operation, thoroughly clean the unit. The axles
and drive shafts should be checked and repaired only by
experienced service technicians who are aware of all
safety instructions and particular component features.
Use suitable products to thoroughly clean all
disassembled mechanical parts to help prevent personal
injury to the worker and prevent damage to the parts.
Carefully inspect the integrity of all moving parts
(bearings, yokes, tubes, gears, shafts, etc.) and fasteners
(nuts, bolts, washers, etc.) as they are subject to major
stress and wear. Always replace any damaged, worn,
cracked, seized or otherwise improper parts that could
affect the safe and proper functioning of the machine,
axles and drive shafts.
5.4 AXLE ASSEMBLIES
5.4.1 Axle Serial Number Plate
The front axle serial number plate is located on a
mounting pad on the inboard portion of the right beam
trumpet. The rear axle serial number plate is located on a
mounting pad on the inboard portion of the left trumpet.
Information on the serial number plate is required in
correspondence regarding the axle.
Supply information from the axle serial number plate
when communicating about an axle assembly or axle
components.
5.4.2 Axle Specifications
General axle specifications are found in Section 2.4,
“Fluid and Lubricant Capacities.”
5.4.3 Axle Internal Service
Detailed axle service instructions (covering the axle,
differential, brakes and wheel-end safety, repair,
disassembly, reassembly, adjustment and
troubleshooting information) are provided in the
appropriate Axle Repair Manual.
8042 - Before S/N 0160038967 including 0160038971 &
0160038984
10042 - Before S/N 0160038368 including 0160038375,
0160038378, 0160038379, 0160038381 &
0160038383
10054 - Before S/N 0160038740 excluding 0160021270,
0160036713, 0160036715, 0160036721 &
0160036723
6036 & 6042
8042 - S/N 0160038967 & After excluding 0160038971 &
0160038984
10042 - S/N 0160038368 & After excluding 0160038375,
0160038378, 0160038379, 0160038381 &
0160038383
10054 - S/N 0160038740 & After including 0160021270,
0160036713, 0160036715, 0160036721 &
0160036723
WARNING
DO NOT service the machine without following all
safety precautions as outlined in Section 1, “Safety
Practices,” of this manual.
Machine ZF Model Axle P/N
8042,10042 &
10054 MS-T 3060 Front 8990430
8042 MS-T 3045 Rear 8990419
10042,10054 MS-T 3055 Rear 8990419
Machine ZF Model Axle P/N
6036,6042 MS-T 3045 II Both 31200694
8042,10042 &
10054 MS-T 3060 II Front 31200695
8042 MS-T 3045 II Rear 31200694
10042,10054 MS-T 3055 II Rear 31200694