SkyTrak 8042 Service Manual - Manual (Page 134)

Engine - Cummins QSB3.3T/QSB4.5T
7-2 6036, 6042, 8042, 10042, 10054
7.1 INTRODUCTION
7.1.1 Disclaimer and Scope
These instructions are written for worldwide use. In
territories where legal requirements govern engine smoke
emission, noise, safety factors, etc., apply all instructions,
data and dimensions provided herein in such a way that
after maintenance, service and repair of the engine,
engine operation does not violate local regulations.
Note: These instructions cover only the routine
maintenance, removal, installation and troubleshooting
of the engine. Refer to the local Cummins Engine
Distributor and the applicable Cummins Engine Service
Manual for assistance with comprehensive engine
diagnosis, repair and component replacement.A gradual
running-in (break-in) of a new engine is not necessary.
Full load can be applied to a new engine as soon as the
engine is put into service and the coolant temperature is
at least 140° F (60° C). Extended light-load operation
during the early life of the engine is not recommended.
DO NOT run the engine at high, no-load speeds. DO
NOT apply an overload to the engine.