Disassembly, Disassembly -7, Connector assembly (3 of 4) -7 – JLG 3248RS/10RS Service Manual User Manual
Page 133: Connector assembly (4 of 4) -7, Ee figure 7-8. connector assembly (3 of 4)), Ee figure 7-9. connector assembly (4 of 4))
Advertising
SECTION 7 - GENERAL ELECTRICAL INFORMATION & SCHEMATICS
3121273
– JLG Lift –
7-7
Figure 7-8. Connector Assembly (3 of 4)
Figure 7-9. Connector Assembly (4 of 4)
Disassembly
5. Insert a 4.8 mm (3/16”) wide screwdriver blade between the mating seal and one of the red wedge lock tabs.
6. Pry open the wedge lock to the open position.
7. While rotating the wire back and forth over a half turn (1/4 turn in each direction), gently pull the wire until the contact is
removed.
Advertising
This manual is related to the following products: