JLG 3248RS/10RS Service Manual - Manual (Page 70)

SECTION 3 - CHASSIS & SCISSOR ARMS
3-38 – JLG Lift – 3121273
3.15 STEER ASSEMBLY COMPONENTS
Figure 3-39. 1932RS/6RS - Steer Assembly
NOTE: Coat all pins with a light coat of molypaste before assembly. Pack inner and outer spindle bearings with multi-pur-
pose grease (MPG) before assembly. Do not overtighten spindle bearing nut. Replace spindle seal if worn, dam-
aged, or leaking.
1. Install the bearing with the flange surface on top of the spindle arm.
2. Assemble the spindle kingpin attach, banjo pin hardware, in the frame hole towards the front of the machine.
3. Install cylinder to frame attach pin with cotter pin hole on top.
1
1
2
3
2