JLG 3248RS/10RS Service Manual - Manual (Page 56)

SECTION 3 - CHASSIS & SCISSOR ARMS
3-24 – JLG Lift – 3121273
8. Remove manual release screws from brake assem-
bly. Apply new Gasket (12) and affix brake cover to
motor using the 2 manual release screws.
9. Attach terminal cover to the commutator end head
using two terminal cover screws.
10. Slide the strain relief of the wire harness into the slot
of the terminal cover. Align cover plate with groove in
frame and field and affix using two cover plate
screws.
Figure 3-25. Drive Motor Shaft Bearing
1. Press Fixture must press against Outer Race
2. Bearing
3. End Head (held stationary)
4. Armature Assembly
5. Assembled End Head, Bearing, and Retaining Ring
6. Press Fixture must press against Inner Race (held stationary)
Figure 3-26. Wire Harness Connections