AirLive WN-300ARM-VPN User Manual
Page 17
AirLive WN-300ARM-VPN User’s Manual
15
Use any of the following Administration Configuration
settings or features:
PC
Database
Config
File
Logs
Diagnostics
Remote
Admin
Routing
Upgrade
Firmware
Chapter 7
Advanced Administration
Configuration Program
The WN-300ARM-VPN contains an HTTP server. This enables you to connect to it, and configure it using
your Web Browser. Your Browser must support JavaScript.
The configuration program has been tested on the following browsers:
Netscape 7.1 or later.
Mozilla 1.6 or later
Internet Explorer 5.5 or later
Preparation
Before attempting to configure the WN-300ARM-VPN, please ensure that:
Your PC can establish a physical connection to the WN-300ARM-VPN. The PC and the
WN-300ARM-VPN must be directly connected (using the Hub ports on the WN-300ARM-VPN) or on
the same LAN segment.
The WN-300ARM-VPN must be installed and powered ON.
If the WN-300ARM-VPN's default IP Address (192.168.0.1) is already used by another device, the
other device must be turned OFF until the WN-300ARM-VPN is allocated a new IP Address during
configuration.
Using your Web Browser
To establish a connection from your PC to the WN-300ARM-VPN:
1. After installing the WN-300ARM-VPN in your LAN, start your PC. If your PC is already running, restart it.
2. Start your WEB browser.
3. In
the
Address box, enter "HTTP://" and the IP Address of the WN-300ARM-VPN, as in this example,
which uses the WN-300ARM-VPN's default IP Address: