AirLive WN-300ARM-VPN - Manual (Page 49)

4.4 Wireless Station Configuration
This section applies to all Wireless stations wishing to use the WN-300ARM-VPN's Access Point, regardless
of the operating system which is used on the client.
To use the Wireless Access Point in the WN-300ARM-VPN, each Wireless Station must have compatible
settings, as follows:
Mode The mode must be set to Infrastructure (rather than Ad-hoc)
Access points only operate in Infrastructure mode.
SSID (ESSID) This must match the value used on the WN-300ARM-VPN. The default value is
Wireless.
Note! The SSID is case sensitive.
Wireless
Security
By default, Wireless security on the WN-300ARM-VPN is disabled.
 If Wireless security remains disabled on the WN-300ARM-VPN, all stations
must have wireless security disabled.
 If Wireless security is enabled on the Wireless Router (either WEP or
WPA-PSK), each station must use the same settings as the Wireless
ADLS Router.
4.5 Wireless Configuration on Windows XP
If using Windows XP to configure the Wireless interface on your PC, the configuration procedure is as follows:
1. Open the Network Connections folder. (Start - Settings - Network Connections)
Figure: Network Connections (Windows XP)
2. Right-click the Wireless Network Connection, check that it is enabled (menu option says Disable, rather
than Enable) and then select View Available Wireless Networks.
3. You will then see a list of wireless networks.
AirLive WN-300ARM-VPN User’s Manual 47