AirLive WN-300ARM-VPN - Manual (Page 43)

3. Select the TCP/IP protocol for your network card.
4. Click on the Properties button. You should then see a screen like the following.
Figure: TCP/IP Properties (Win 2000)
5. Ensure your TCP/IP settings are correct, as described below.
Using DHCP
To use DHCP, select the radio button Obtain an IP Address automatically. This is the default Windows
setting. Using this is recommended. By default, the WN-300ARM-VPN will act as a DHCP Server.
Restart your PC to ensure it obtains an IP Address from the WN-300ARM-VPN.
Using a fixed IP Address ("Use the following IP Address")
If your PC is already configured, check with your network administrator before making the following changes.
 Enter the WN-300ARM-VPN's IP address in the Default gateway field and click OK. (Your LAN
administrator can advise you of the IP Address they assigned to the WN-300ARM-VPN.)
 If
the DNS Server fields are empty, select Use the following DNS server addresses, and enter the DNS
address or addresses provided by your ISP, then click OK.
AirLive WN-300ARM-VPN User’s Manual 41