Mounting the trombone – ElmoMC SimplIQ Digital Servo Drives-Trombone Installation Guide User Manual
Page 21
Trombone Installation Guide
Installation
MAN-TROIG (Ver. 1.403)
21
3.4. Mounting the Trombone
The Trombone (Figure 2) is designed for mounting on a printed circuit board (PCB). It is
connected by 2 mm pitch 0.51 mm square pins and 2.54 mm pitch 0.64 mm square pins. When
integrating the Trombone into a PCB, be sure to leave about 1 cm (0.4") outward from the heat
sink to enable free convection of the air around the Trombone. We recommend that the
Trombone be soldered directly to the board. If the PCB is enclosed in a metal chassis, we
recommend that the Trombone be screw-mounted to it as well to help with heat dissipation.
The Trombone has screw-mount holes on each corner of the heat sink for this purpose.
All dimensions are in mm.
Figure 2: Trombone Dimensions