A three-phase direct-to-mains connection topology, Figure 6 – ElmoMC SimplIQ Digital Servo Drives-Trombone Installation Guide User Manual
Page 29
Advertising
Trombone Installation Guide
Installation
MAN-TROIG (Ver. 1.403)
29
3.7.2.1.a
Three-Phase Direct-to-Mains Connection Topology
Figure 6: Non-Isolated Three-Phase Connection Topology
Caution:
Do not connect VN- to PE. In a direct-to-mains connection, the VN- must not be
connected to the PE, as this will cause irreparable damage to the system.
Take care to note that in a direct-to-mains connection the Neutral point is not
the most negative voltage level. It is the mid-point level of the rectified DC bus.
Advertising