ElmoMC SimplIQ Digital Servo Drives-Trombone Installation Guide - Manual (Page 44)

Trombone Installation Guide Installation
MAN-TROIG (Ver. 1.403)
www.elmomc.com
44
3.10. Auxiliary Feedback
For auxiliary feedback, select one of the following options:
a. Single-ended emulated encoder outputs, used to provide emulated encoder signals to
another controller or drive. The Emulated Encoder Output option is only available when
using a resolver, interpolated analog encoder, tachometer, potentiometer or absolute
encoder as the main feedback device.
This option can be used in the following scenarios:
 The Trombone is used as a current Servo-Drive to provide position data to the position
controller.
 The Trombone is used in velocity mode to provide position data to the position
controller.
 The Trombone is used as a master in follower or ECAM mode.
b. Single-ended auxiliary encoder input, for the input of position data of the master encoder
in follower or ECAM mode.
c. Pulse-and-direction input, for single-ended input of pulse-and-direction position
commands.
When using one of the auxiliary feedback options, the relevant functionality is selected by the
software for that option. Refer to the SimplIQ Command Reference Manual for detailed setup
information.