Unpacking the drive components – ElmoMC ExtrIQ Digital Servo Drives-Falcon User Manual
Page 19
Falcon Installation Guide
Installation
MAN-FALIG (Ver. 1.502)
19
Component
Wire
Described
in Section
Drawing
CAN
Communicatio
n cable(s) (if
needed)
CAN (in)
CAN (out)
PC for drive
setup and
tuning
Motor data
sheet or
manual
3.2. Unpacking the Drive Components
Before you begin working with the Falcon system, verify that you have all of its components, as
follows:
•
The Falcon servo drive
•
The Composer software and software manual
The Falcon is shipped in a cardboard box with Styrofoam protection.
To unpack the Falcon:
1.
Carefully remove the servo drive from the box and the Styrofoam.
2.
Check the drive to ensure that there is no visible damage to the instrument. If any damage
has occurred, report it immediately to the carrier that delivered your drive.
3.
To ensure that the Falcon you have unpacked is the appropriate type for your
requirements, locate the part number sticker on the side of the Falcon. It looks like this: