Powering up, Initializing the system, Powering up 3.6. initializing the system – ElmoMC ExtrIQ Digital Servo Drives-Falcon User Manual
Page 54
Advertising
Falcon Installation Guide
Installation
MAN-FALIG (Ver. 1.502)
54
3.5. Powering Up
After the Falcon has been mounted, check that the cables are intact. The Falcon servo drive is
then ready to be powered up.
Caution:
Before applying power, ensure that the DC supply is within the range specified
for your specific type of Falcon and that the proper plus-minus connections are
in order.
3.6. Initializing the System
After the Falcon has been connected and mounted, the system must be set up and initialized.
This is accomplished using the Composer, Elmo’s Windows-based software application. Install
the application and then perform setup and initialization according to the directions in the
Composer Software Manual.
Advertising