JUMO 14597 safetyM STB/STW Ex - Safety Temperature Limiter and Safety Temperature Monitor Operating Manual - Manual (Page 103)

8 Configuration level 97 2013-04-01
8.4 Binary input
k
Factory setting
Parameter Comment
Value range
(factory setting in bold)
8.4.1 Function This sets the function that should be controlled by the binary
input.
The binary input does not have a function No function
The binary input performs a reset as described in Chapter 8.3.1
"Device function"
The function only responds to the switching edge from "open" to
"closed" state. Unlocking
Protection against unauthorized key operation Key lock
Configuration level is locked. Level inhibit