Lenze ApplicationTemplate PackML (PLC Designer R3-x) - Manual (Page 4)

About this documentation
4
Lenze · ApplicationTemplate PackML · 1.0 EN - 05/2014
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
1 About this documentation
This documentation describes the operating mode of the Lenze "ApplicationTemplate PackML"
which serves as a basis for programming a Lenze automation system. The used "Controller-based
automation" system consists of a Lenze Controller and drive components which are connected via
the bus system.

Tip!
Information and tools regarding the Lenze products can be found in the download area at:
http://www.Lenze.com
This manual is part of the "Controller-based Automation" manual collection. The manual collection
consists of the documents:

Note!
This documentation is a supplement to the »PLC Designer« online help.
Type of documentation Subject
System manuals System overview/example topologies
• Controller-based Automation
• Visualisation
Communication manuals Bus systems
• Controller-based Automation EtherCAT®
• Controller-based Automation CANopen®
• Controller-based Automation PROFIBUS®
• Controller-based Automation PROFINET®
Online helps/
software manuals
Lenze Engineering tools
• »PLC Designer«: Programming
• »Engineer«: Configuration of controllers
• »VisiWinNET® Smart«: Visualisation
• »Backup & Restore«: Backing up/restoring data